Replacement model guide
Enidine LROEMXT 1.5M x 2 replacement option: EKL42X50 comparison
Compare published Enidine LROEMXT 1.5M x 2 ratings with the EKD EKL42X50 candidate and confirm the actual application conditions.
Browse Enidine OEMXT low-rate modelsListed interface values match; performance and drawing review required Final selection requires operating data and a drawing review.
Published parameter comparison
The table compares published catalog values. A higher rating can identify a performance candidate, but it does not remove mounting, force, reset, environment or application checks.
| Parameter | Enidine LROEMXT 1.5M x 2 | EKD EKL42X50 | Assessment |
|---|---|---|---|
| Energy per cycle | 850 J (Nm) | 850 Nm/C | Matched reported value A catalog rating comparison only; effective mass, drive force and deceleration remain application checks. |
| Energy per hour | 167,000 J/h | 167,000 Nm/h | Matched reported value Confirm the actual cycle rate and thermal conditions. |
| Stroke | 50 mm | 50 mm | Matched reported value Confirm usable travel, stop position and reset clearance. |
| Body thread | M42 x 1.5 | M42 x 1.5 | Matched reported value Nominal body-thread designation matches; verify thread tolerance, mounting geometry and available envelope before ordering. |
| Nominal total length | 195 mm | 195 mm | Matched reported value Check the drawing reference points, installed envelope and rod-end geometry. |
| Impact velocity | 0.08–1.3 m/s | 0.08–1.3 m/s | Inquiry confirmation required Compare the real operating point, not only the published maximum. |
| Published force limit | 20,000 N | 20,000 N max impact force | Inquiry confirmation required The manufacturers may define force ratings differently; verify the machine limit and deceleration curve. |
What must be matched and confirmed
- Actual moving mass, impact velocity and drive force
- Mounting thread, stop geometry and available envelope
- Cycle rate, return time and permissible deceleration
- Temperature, corrosion, alignment and side loading
Continue with EKD review
Open the EKD candidate, then use the matching tool or send the original nameplate, drawing and application data. EKD will confirm the remaining differences before ordering.
Sources and boundary
Original product source: https://www.enidine.com/getmedia/b2a382ab-3ee7-4877-8754-5462300da76e/Shock_Catalog.pdf
EKD candidate source: https://www.vibroabsorber.com/products/shock-absorbers/ek-adjustable-shock-absorbers/ekl42x50
Brand names and model numbers identify the user's existing product for comparison. EKD does not claim the original brand's certification, design ownership or guaranteed interchangeability. Final selection requires application confirmation.